Movitronic KeyBox.One Device Setup Manual
Movitronic KeyBox.One comes with:
- OBD cable
- GPS antenna.
- Key-cradle including battery emulator (inside the box).
You need a T15 and Phillips screwdriver to open the box and cradle, as well you need something that helps you open the car keyfob.
Step 1
Now you need to open the keyfob to remove the battery.
Step 2
After removing the battery from the keyfob, you need to open the box by unscrewing screws from the bottom.
Step 3
Then you need to open the key cradle by removing the Philips screws.
Step 4
Now you have to insert the battery emulator inside the remote, instead of the battery.
- Close the lid of the keyfob being caution about the ribbon cable so it would not snap
- Keyfob buttons must be upside
Step 5
When the key is inside the cradle, attach the top plate and fix it with 4 screws.
Step 6
Now, put the cradle inside to the top part of the box, cable facing the side where is the cut-out for the cable plug sockets.
Step 7
You might receive the device in transport mode, battery being physically disconnected from a device. To start, you need to make sure that the battery jumper is being connected, so the device can run on an internal battery.
Battery jumper disconnected in transport mode (jumper open)
Step 8
After this the box can be put back together by screwing bolts on the bottom side.
NB! Do not forget to store your car key part and battery in a safe place!
KeyBox.One LED Indicators
When you have connected the device to the ODB port, then the led lights on top of the connection port show different statuses.
Condition
Orange/Yellow
Green
Blinking on connection.
Needs 12V
- Kenneth Pohl
- Ph. +372 5674 8884
- kenneth.pohl@movitronic.com
- Alison Lee
- +44 0 33 3303 1086
- Send Email
- Kenneth Pohl
- +372 5674 8884
- Send Email
